Manual and Procedure

How to Operate a Manual Camera

Instructions

1. Open the back of the camera by pressing down the latch typically located on the right side of the camera. 
2. Select and load the film. Close the back of the camera and wind the film onto the spool until the frame counter on the top left of the camera reads "1. 
3. Set the film speed using the dial located on the top left of the camera. 
4. Set the shutter speed on top of the camera and the aperture on the camera lens using either a built-in or handheld light meter to determine the correct settings. 
5. Slip the flash, if you're using one, into the hot shoe on top of the camera, and turn the mount on the bottom of the flash to secure it. Turn on the flash and set the shutter speed at 1/60th of a second. 
6. Choose a lens and attach it by aligning the dot on the camera body with the dot on the base of the lens. Some cameras have a lens release next to the lens. Turn the lens base until it's firmly attached to the camera body. 
7. Look through the viewfinder window and focus the camera by turning the focusing ring on the lens. 
8. Frame the image and press the shutter release on the top right of the camera to take a picture. 
9. Wind the film to the next frame. 
10. Rewind the film when you reach the end of the roll; open the back; and remove the film.

How to Use a Printer

                                                                       

Instructions

1. Using a printer even basic printer is extremely easy to do. There are many different models of printers out there. You have your very basic to your all-in-one printer. The printer with everything on it works pretty much just like the regular printer you just have a lot more buttons to push. 
2. Make sure that your printer is hooked up properly before using it. If this is a brand new printer then it will go through a check and print out a test page for you. A lot of different times you can just turn it on, you will hear the ink moving around. Something might come up on the computer telling you that the printer is on and working properly. 
3. Open the page you want to print. If you are on the Internet and want to print something from there. All you have to do is go up to file, then down to page set up. This will give you more printing options to choose from. When you are done setting up the page you can verify you have the right printer hooked up by clicking on "Printer" at the bottom. Once everything looks good click on "OK" and now your page should print out. 
4. Open up a ".doc" file if that is where your page is that you need to print. When you are ready to print go up to "File" and "Print Setup". Again you can choose how you want your page to look, and check and make sure the right printer is installed. If your page is set up the way you like it you can just click on the printer icon on the tool bar or go to "File" then "Print. 
5. Using a printer a lot over time will start to wear down your ink supply. Some models of printers let you know when your ink supply is getting low. If you have an older printer you will just have to go by what the printed page looks like. If it is very worn and faded then it is time to install a new ink cartridge.